2011年2月14日星期一

LED screen common fault solution

LED screen common fault solution
A load on or not, the communication is not what is the root cause of?
Communication is not with load not the reason is roughly same, probably due to the following causes, please according to the listed above and operating comparison:
1, ensure control system hardware have right to electricity. (+ 5V)
2, examine, and confirmed to be used in connection of serial line for direct controller line, not cross lines.
3, check and monitor the serial connecting intact and ends without loosing or falls off phenomenon.
4, controlled LED display control software and oneself chooses control card to choose the right product model, the correct transmission mode of serial number, and correct the correct serial transmission rate and controls software provided to dial the code switch diagram properly setting control system hardware to address bits and serial transmission rate.
5, check jumper cap is loose or shedding, If jumper cap without loosing phenomenon, please ensure jumper cap the right direction.
6, such as through above check and after correction still appear on, please load not using a multimeter to measure whether the connected computers or control system hardware of serial damaged, to confirm whether it should be sent back computer or manufacturer will control system hardware back detection.

Second, LED panel just on electricity occurs when a few seconds of bright line or screen picture becomes flower reason?
Will screen controller with computers and on board and screen connected properly distribution, need to give controller provides + 5V power to make the normal work (right now, not directly with connected 220V voltage). The electricity instant, will appear on the screen of a second bright line or "flower screen", this bright line or "flower screen" all is normal phenomenon, remind consumer test the screen will begin to work properly. 2 seconds, this phenomenon automatic eliminate, screen into normal working condition.
Third, automatically or manually brightness to adjust what's that supposed to mean?
Brightness adjusting refers to the screen can show the most dark and the brightest between made adjustment, rather than photosensitive adjustment. Automatic brightness adjusting is according to different time periods which should appear different brightness and by being rich LED screen control system automatically adjusts to a predetermined brightness. Manual brightness adjusting refers to the end user through to led sign control system operation, let the led display attain a designated brightness.
Four, unit board appears full wafer screen not bright, dark bright
1, visual power source jumper, unit board between 26P row line and power module indicator light is normal or not.
2, using a multimeter to measuring unit board, again without normal voltage measuring voltage output power module is normal or not, otherwise, the judge for power supply module bad.
3, measuring power module, adjust the micro-tensioning (low voltage power supply module near indicator of fine-tuning) that the voltage in up to standards.
Five, the LED display screen appears screen all-black reason is?
In control system used in the process, we occasionally meet led sign appears screen all-black phenomenon. The same phenomenon may be by various causes, even screen blackened process will rejoice at different operation or due to different environment and different. For example it could be a moment of the electricity is black, also may in loading process turning black, may also be sending after the completion of the black etc:
1, please ensure that includes control system, in all hardware have all right to electricity. (+ 5V, don't pick up against, answer the wrong)
2, examine, and repeated confirmation connects to a controller of serial line if there's any loose or falls off phenomenon. (if in loading process black, probably because the reason is caused, be in namely communication process due to communication line loose and interrupt, therefore screen to blacken, don't assume screen body did not move, line is impossible to loose, please begin to check, this to want to quickly solve the problem very important).
3, check and monitor connection led panel and with the monitor system card connected on distribution board, whether is closely connected to whether inserted reversed.


led billboard  outdoor led display   led tube led spotlight led bulb led par light signle led billboard manufacturer in China

没有评论:

发表评论